Heinner VMGB001 Anleitung Seite 6

tightened or loosened in the opposit direction of a
usual nut).
The nut must be re-tightened every time before
use.
Never attempt to cut a tree, a log, wood or other
hard materials.
The cutter blade must be well clean, sharp and free
of cracks or breakage.
If the cutter blade contacts any hard objects or
stones during operation, stop the engine and check
the blade immediately.
Clean and sharpen or replace the cutter blade at
least every three hours of operation.
The outside diameter of the cutter blade must not
exceed 255mm.
FUEL
This brush cutter is powered by a 2-stroke engine
that requires a petrol/oil mixture as fuel.
Please use only 2-strokes oil and unleaded
gasoline.
Never use a gasoline mixture which contains
engine oil. Otherwise, it will cause excessive
carbon accumulation or mechanical troubles. Use
of deteriorated oil will cause irregular startup.
GASOLINE GRASS TRIMMER
Loosen the tank cap a little so that there will be no
difference in atmospheric pressure.
Detach the tank cap, and refuel, discharging air by
tilting the fuel tank so that the refuel port will be
oriented upward.
Wipe well the periphery of the tank cap to prevent
foreign matter from entering into the fuel tank.
After refuelling, securely tighten the tank cap.
Never do a full refuel.
If there is any flaw or damage on the tank cap,
replace it.
Handling of Fuel
It is necessary to handle fuel with utmost care. Fuel
may contain substances similar to solvents.
Refuelling must be performed in a well ventilated
room or in the open air. Never inhale fuel vapor,
and keep fuel away from you. If you touch fuel
repeatedly or for a long time, the skin becomes
dry, which may cause skin disease or allergy. In
case of eye contact with the fuel, clean the eye
with fresh water. If your eye remains irritated,
consult your doctor.
Storage of Fuel
Fuel should be used up within a period of 4 weeks,
even if it is kept in a special container in a well-
ventilated place.
If a special container is not used or if the container
is not covered, fuel may deteriorate in one day.
Keep the machine and tank at a cool place away
from direct sunshine.
Operation
Use the brushcutter only in good light and visibility.
Always ensure a safe footing.
5