Heinner VMGB001 Anleitung Seite 5

Mounting of control cable
Remove the air cleaner cover. Place the control
cable (4) in the adjusting bolt (5), and shift the
swivel (6) so that the cable will be put in the swivel
groove. At this time, the round-hole side of the
swivel will be oriented toward the inner wire end-
metal fitting.
Release the swivel, and confirm that the inner
wire-end metal fitting will be placed in the hole.
Mount the air cleaner cover.
Connection of switch cord
- Connect the switch cords to the two cords from
the engine by inserting one into the other.
- Fix the cord connector by clamp (7).
Adjustment of control cable
- Adjust the control cable by adjusting bolt so that
it will have 1 to 2 mm play when the throttle lever
is set to the low-speed position by carburetor
adjusting bolt.
GASOLINE GRASS TRIMMER
Make the throttle wire and I-O switch cords go
along the flexible pipe and fix three point them on
clip wire (8) tightly. If you do not fix the throttle
wire and I-O switch cords surely, there is fear that
they catch on the branch and so on it is dangerous.
Fix the loop handle to the drive shaft by tightening
the 2 bolts firmly. Do not adjust the handle too
close to the control grip. Keep not less than 25 cm
distance between the handle and the grip.
Mounting the protection
The appropriate guard must always be
installed, for your own safety and in order
to comply with accident-prevention regulations.
Fix protector to the drive shaft by 2 bolts firmly.
Mounting of cutter blade
Note: Always wear gloves when handling the cutter
blade.
Turn the machine upside down, and you can
replace the cutter blade easily.
Thrust a bar or alien wrench into a hole of the gear
case until the cutting blade is locked and will not
turn. Tighten a nut by turning counter-clockwise
with a combination wrench (Note that the nut is
4