Getting Started - Phonocar VM 016 Montageanleitung

Getting Started

Press the button to open the panel and press
PANEL STATUS INDICATOR
Remote control operating range
The remote control can operate within a distance of 3~5m.
Replacing the lithium battery of remote control
When the range of the operation of the card remote control becomes short or no functions while operating,
replace the battery with a new lithium battery. Make sure the battery Polarity replacement is correct.
1. Pull out the battery holder while pressing the stopper.
2. I nsert the button-type battery with the stamped(+) mark facing upward. Insert the battery holder into the
remote control.
WARNING
• Store the battery where children cannot reach. If a child accidentally swallows the battery, consult a doctor
immediately.
• Do not recharge, short, disassemble or heat the battery or dispose it in a fire.
• Do not expose or bring into contact the battery with other metallic materials.
• Doing this may cause the battery to give off heat, crack or start a fire.
• When throwing away or saving the battery, wrap it in tape and insulate; otherwise, the battery may give off
heat, crack or start a fire.
Slot, Insert disc
Light up when you slide the
panel down; flashes when
you remove the panel.
to eject the disc.
Disc Eject
RESET HOLE
Note: Pressing the RESET button
by inserting a pointed tool such as
the end of an unbent paper clip.
36
SD/MMC Card Slot
Remote control