Herunterladen Inhalt Inhalt Diese Seite drucken

Heart Rate Monitor; Power Sensor Calibration; Cadence Sensor; Copyright - eLine DIRETO Anleitung

Interactve power meter trainer
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 34
EN
- Off = Direto is not receiving power or has the entered sleep
mode
- On = Direto is powered up.
Green = Direto is connected via the ANT+™ protocol.
- Blinking = Direto is awaiting connection.
- On = Direto is transmitting data via the ANT+™ protocol.
Blue = Direto is connected via the Bluetooth Smart protocol.
- Blinking = Direto is awaiting connection.
- On = Direto is transmitting data via the Bluetooth Smart pro-
tocol.

HEART RATE MONITOR

- Direto hometrainer does not read heart rate
monitor data. Heart rate monitor data can be read
directly from a device that includes a heart rate
function.
- Compatibility with various types of heart rate
monitors depends on the device / software / app being used
only ANT+™ and is also compatible
with Bluetooth Smart monitors allowing connection with moni-
tors by both protocols.

POWER SENSOR CALIBRATION

Direto can calibrate the internal power measurement system,
which clears the system settings in order to always obtain ac-
curate power values.
The process is very simple, just select any type of training on
the home trainer and train for at least 5 minutes, then perform
the appropriate function - works on both the My E-Training sof-
tware and the My E-Training app.
The calibration command in the mobile version can be found
in Parameters – Advanced Configuration – Home trainer cali-
bration, while in the desktop version it can be found in Settings
– Home trainer calibration.
This is accomplished by pedalling and increasing speed until
you reach a certain indicated value.
Remember to stop pedalling at the system prompt.
After a few seconds the system will indicate that the calibration
process was successful.
This value is then stored in the Direto's memory, and accurate
power data will be received from every connected device, inclu-
ding non-Elite third party software / app / devices.
Please note: the aforementioned calibration procedure can be
conducted with software / app / devices other than the Elite
ones.

CADENCE SENSOR

The Direto uses an innovative "sensorless" system and it's
obtained via sophisticated power-based calculations.
When maintaining a high pedal cadence at low resistance le-
40
vels, there may occasionally be a slight inaccuracy in the ca-
dence value since it is the result of calculation and not direct
monitoring. This occurs especially with fast pedalling and low
resistance.
Should you wish for more accuracy than what the "sensorless"
system can give you, you can use a wired sensor (not included)
available for purchase via shop-Elite or authorized retailers.
For installation on the bike, follow the instructions on the en-
closed manual.
To activate the cadence detection via the sensor, connect the
sensor to the Direto
Some software allows the use of wireless sensors connected
directly to the app/software/device. In this case, please consult
the specifications of the software / app / device to verify its
compatibility with wireless cadence sensors.

COPYRIGHT

No part of this manual may be reproduced or transmitted wi-
thout the written authorization of Elite S.r.l.
The Elite Direto software and relative code are property of Elite
S.r.l.
International copyright law protects the software.
The Elite Direto software must be treated like any other copy-
righted material, such as books.
Users undertake not to modify or adapt the programme. Users
also undertake not to decompile, disassemble or attempt in any
way to discover the native software code.

NOTE

- Elite cannot be held responsible for any malfunction involving
third party software / app / device.
- The presence of high-voltage electric lines, traffic lights,
electric railway lines, bus or tram electric lines, television sets,
automobiles, cycle computers, gym equipment and mobile
phones inside the operating range of the console, etc., can be
the cause of interference. Therefore the use of other wireless
receivers may alter or completely inhibit operation of the Direto
due to such interference.
- Do not expose the Direto to direct sunlight for long periods
when they are not in use.

DISCLAIMER

Elite S.r.l. is not liable for any temporary or permanent damage
to the physical integrity of the user, whether direct or indirect,
resulting from the use of the trainer.
ATTENTION!
Direto is equipped with a freehub body compatible with

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis