Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5
SETUP
Mounting
The pinspot easily attaches to metal surfaces with its magnetic base (remove
clip for this) or to drop ceilings with its scissor clip. Adjust the desired pan and
tilt angles.
Battery Operation
The pinspot features a rechargeable lithium battery for cable-free operation.
Prior to initial use, completely charge the battery.
1
Connect the charger to the power input at the pinspot and the mains
plug to a mains outlet (230 V AC, 50 Hz). The indicator light on the
charger turns red while the battery is charging, then it turns green
when the battery is done charging. The battery can be charged
before, during or after operation. To charge the battery with the LED
off, leave the power switch in the off position.
2
The device features a protective circuit for charging which prevents
overload of the rechargeable battery. However, disconnect the device
from the mains after charging. Otherwise there will be a low current
consumption even if the device is switched off.
3
The device will heat up during charging; this is normal.
4
To prevent damage to the battery by deep discharge, recharge a
battery completely discharged as soon as possible. Do not store the
unit with the battery completely discharged and regularly recharge the
battery in case of long storage.
Maximum battery run time
www.eurolite.de
6 hours
18
Recharge time
3 hours
Werbung
Inhaltsverzeichnis
