The Charger; Technical Specifications; Powering The Charger; Installing The Terminals - Adeunis RF VOKKERO Squadra Bedienungsanleitung

8. The charger
The Vokkero® Squadra charger is a straightforward product that enables the terminals' internal batteries to be rechar-
ged and enables the configurator to be powered.
Up to 3 chargers may be placed in series, thus enabling the simultaneous charging of 12 terminals.
A single power supply unit is required for powering the chargers in series and the configurator. Make sure you use the
power supply unit supplied by Adeunis RF when your Vokkero® Squadra kit is delivered.
Note: Depending on the intended use, the ARF7675AA battery charger is delivered with a European or North Ame-
rican power supply cable. For the other countries (European or elsewhere) requiring a specific power supply cable,
please use a mains plug that complies with local standards.
8.1. Technical specifications
AC/DC power supply converter
Operating temperature
Charging time
Dimensions
Battery autonomy
8.2. Powering the charger
• Connect the power supply unit to the socket located on the back of the charger.
• Connect the power supply unit to the mains.
• The charger is ready for use.
8.3. Installing the terminals
• Place the terminals in the positions designed for that purpose (4 per charger). Insert them vertically so that you
do not damage the connector.
• When the terminal is detected, charging will start. The terminal's battery icon will rise incrementally, confirming
that the charging is in progress. If the relevant indicator light does not light up, check that the terminal has been
correctly positioned.
• If the configurator is connected to the charger, battery icons will appear alongside each of the terminals, indica-
ting the state of progress with the charging (cf. section 8.3.1).
• To remove the terminals from the charger, tilt them forward. Note:when the terminals are removed from the char-
ger, they switch off automatically, you must switch them on to use them.
208407A-V1.4-UG-VOKKERO-SQUADRA_CEE_REFEREES
100 to 240 V ~ 12Vdc - 5 A-50 to 60 Hz
5°C to 40°C (41°F to 104°F)
5 hours
L 136 mm * H: 38 mm * D: 68 mm
> 500 cycles
48