Dual CS 455-1 Bedienungsanleitung Seite 7

A
utomatic start, speed selection 33/45
– The speed must be selected according to the record which
is in place. If the turntable speed is set to 33 or 45 rpm 6
the record size is automatically selected for the automatic
start. The speed setting switch 78 8 must be turned to OFF.
– Remove stylus cover forwards for the pick-up stylus and
move switch 10 to Start. The pick-up arm automatically
lowers onto the record.
M
anual start, speed selection 33/45/78, cue control
– The speed must be selecte d according to the record which
is in place. Use switch 6 to select a speed of 33 or 45 rpm,
the speed setting switch 78 8 must be turned to OFF.
For 78 rpm move speed setting lever 6 to 45 and switch 78
8 to ON.
– Remove stylus cover forwards and move lift lever 5 into po-
sition .
– Now position the tonearm over the lead-in groove of the re-
cord. The tonearm is now lowered slowly onto the record
using the cueing lever 5
thus preventing damage to your records.
– The tonearm can be raised at any position, also for brief in-
terruptions when playing, by means of the cue control lever
(cueing lever in position
in this case.
S
top
– At the end of record, the tonearm is automatically repositio-
ned back on the tonearm post and the unit is switched off.
– You can also switch off the turntable by setting switch 10 to
Stop or setting the cueing lever 5 to position
tioning the tonearm on the tonearm post.
. The tonearm is lowered slowly,
). The platter continues to rotate
and reposi-
C
hanging and fitting the cartridge
A ½ inch cartridge with a net weight of 3...10 g can be fitted in
place of the cartridge already fitted.
– Loosen screw 9 and remove the head shell by pulling it for-
ward (fig. 5). Remove the cartridge by loosening the two se-
curing screws 11.
– Pull off the connection wire on the cartridge. Attach the new
cartridge, at first loosely, on the head shell. Secure the
connection wires with the connection pin on the cartridge.
Red R = right channel, white L = left channel, green RG =
right channel ground, blue GL = left channel ground.
– Replace the head shell on the tonearm and secure screw
9.
– Attach the cartridge with the aid of the system installation
gauge.
– This has been correcty installed if the tip of the stylus -
viewed from above - is in the V-shaped recess of the
system installation gauge. Viewed from the side, the stylus
must be in the area of the rectangular recess (fig. 7).
S D
tylus N 10 resp.
The stylus is subjected to natural wear and tear during playing.
We therefore recommend regular checks, which should be
carried out after at least 300 playing hours in the case of dia-
mond-tipped styli. Worn out or damaged (chipped) styli
damage records. In the event of a replacement being
necessary, use only a DN 10 stylus for 33/45 rpm and DN 167
stylus for 78 rpm. Other styli often cause audible reductions in
quality and increased wear to records. Remove the stylus by
pulling it dia-gonally downwards. To fit a stylus in follow the
procedure in re-verse order (fig. 5).
8
D
N 167