MADRIX LUNA Kurzanleitung Seite 12

Using DMX-OUT Via USB
You can connect MADRIX
the MADRIX software. Data is sent to MADRIX
®
distributed to the XLR output ports ('DMX 1 – DMX 4/8/16').
Follow these quick steps to configure USB output in MADRIX
Step 1) Connect LED controllers/fixtures to the XLR ports of MADRIX
Step 2) Connect MADRIX
Step 3) Connect MADRIX
using the provided USB cable.
Step 4) Start MADRIX
'Preferences...' à 'Matrix Generator...' or à 'Patch...'.
Step 5) Enable USB drivers in MADRIX
and select the tab 'Devices USB'. Activate 'MADRIX LUNA interfaces',
press 'OK', and restart MADRIX
Step 6) Configure DMX output. Go to 'Preferences...' à 'Device Manager...'
à'DMX Devices' and activate 'Enable' for each required output port.
For more information, please read the MADRIX
Device Configuration In MADRIX
Web Configuration
You can access the web configuration interface through MADRIX
is configured. Go to 'Preferences...' à 'Device Manager...' à 'Art-Net'. Your
MADRIX LUNA device is shown in the list with its IP address. Select your device
®
and press 'Config By Web'. Your default web browser will open automatically.
LUNA Configuration
In MADRIX , go to 'Tools...' à 'LUNA Configuration...' to call up the MADRIX
®
LUNA Configuration dialog. The same settings from the web configuration
interface will be available.
For more information, please read the MADRIX
11
LUNA directly via USB to the computer that runs
®
LUNA to power.
®
LUNA to a free USB 2.0 port of your computer
®
and configure your virtual LED matrix using
®
. Go to 'Preferences...' à 'Options...'
®
LUNA via USB cabling and
®
.
®
user manual.
®
®
user manual.
®
:
®
LUNA.
®
, if Art-Net
®
®