Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Pa in t in g In s t r u c t io n s
Notes on Painting AC Schnitzer Components
Before painting, check the fit of all AC Schnitzer bodystyling components on the vehicle (e.g. support surfaces/contours).
Any retouching work (e.g. sanding of support surfaces/contours) should be carried out before painting!
The quality and durability of the paint on a component depend on the preparation and are affected by external influences,
and cannot therefore be compared with other body parts.
To prevent distortion/deformation during processing and drying, AC Schnitzer components must be placed on a
corresponding jig.
Note!
The manufacturer's painting instructions must be followed!!
Painting Steps:
1. Clean:
2. Temper:
3. Inspect:
4. Sand:
5. Mask off:
6. Clean:
7. Fill:
8. Dry:
9. Remove:
10. Sand:
11. Clean:
12. Mask off:
13. Paint:
14. Dry:
AC Schnitzer - automobile Technik - Neuenhofstraße 160 - 52078 Aachen - Tel. 0241/5688 -130
Plastic cleaner / Silicone remover
30 min. at max. 40° Celsius object temperature
Sand down surfaces edges and seams (any pores) if required
2K stopper P220 – P280 (dry), complete component P400 – P600 (dry)
Contact surfaces, TÜV plate, rating plates
Silicone remover
2K HS-filler
1 hour at max. 40° Celsius object temperature, leave component in drying
cabinet overnight
Masking on rating plates, contact surfaces and TÜV plate
P800 (dry)
Silicone remover
Contact surfaces
Note manufacturer's technical data and painting instructions
1 hour at max. 40° Celsius object temperature, leave component in drying
cabinet overnight
Painting Instructions Issue: 10/2010
8
Fax -135
Werbung
