Removing And Emptying The Grass Catcher - Miogarden ARM3740Li Originalbetriebsanleitung

Switching on/off the power tool
Switching on
For convenient handling the unit has four
On/Off switches on the handlebar.
 Press the switch interlock and hold
down (1.).
 Press any On/Off switch (2.).
The motor runs.
Switching off
 Release the On-/Off-switch.
WARNING!
!
After release the On/Off switch, the cutter
bar continues running briefly. Risk of injury!
28
Battery state of charge
The unit has a LED state of charge indicator
on the handlebar. In addition, the charge
status can be checked directly on the
battery.
 Press the button to check the state of
charge at the state of charge indicator
LEDs.
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.
Removing and emptying the
grass catcher
If clippings are left lying on the ground or if
the level indicator on the grass catcher is
closed (with the motor running) , the grass
catcher bag is full and should be emptied
immediately.
ARM3740Li