Miogarden ARM3740Li Originalbetriebsanleitung Seite 22

 Do not switch on the motor until your feet
are at a safe distance from the cutter bar.
 Be careful and do not reach into the
rotating cutter bar.
 Switch the lawnmower off before tilting or
transporting it, e.g. from/to lawn or over
paths.
 Never run over gravel while the motor is
running. There is a risk of being hit by
stones!
 Before lifting or transporting the lawn-
mower, switch the motor off, pull out the
safety key and wait until the cutter bar has
come to a standstill.
 Do not adjust the cutting height until the
motor has been switched off and the cutter
bar has come to a standstill.
 Never open the discharge flap while the
motor is running.
 Before removing the grass catcher, switch
the motor off and wait until the cutter bar
has come to a standstill. After emptying the
grass catcher, carefully re-attach it and
ensure that the grass catcher is attached
securely to the lawnmower.
 If possible, do not mow wet grass.
 Do not work with the garden tool in a
potentially explosive environment in which
there are flammable liquids, gases or dust.
The unit may generate sparks which could
ignite the dust or the vapours.
 When interrupting work, never leave the
unit unattended and keep it in a safe place.
After using the unit
 Switch the unit off, remove the safety key
and then place the unit in a safe location.
 Do not keep the unit within the reach of
children.
 Ensure that the ventilation slots in the unit
are clean.
 Keep all nuts, bolts and screws tight to be
sure that the lawnmower is in safe working
condition.
 Check the grass catcher frequently for
wear or damages.
22
 Use only the cutter bar, which are intended
for this lawnmower.
 Spare parts must conform with the require-
ments specified by the manufacturer.
Therefore use original spare parts only or
spare parts authorised by the manufac-
turer. When replacing parts, please follow
the supplied installation instructions and
remove the battery beforehand.
 Have repairs carried out exclusively by
a qualified technician or a service centre.
Safety instructions for the battery
charger
 Keep the battery charger away from rain or
moisture. Penetration of water in the
battery charger increases the risk of an
electric shock.
 Keep the battery charger clean.
Contamination can lead to danger of an
electric shock.
 Before each use, check the battery
charger, cable and plug. If damage is
detected, do not use the battery charger.
Never open the battery charger yourself.
Have repairs performed only by a qualified
technician and only using original spare
parts. Damaged battery chargers, cables
and plugs increase the risk of an electric
shock.
 Do not place any objects on the battery
charger and do not place the battery
charger on soft surfaces.
There is a risk of fire.
 Always check that the mains voltage
matches the voltage indicated on the rating
plate of the battery charger.
 Never use the charger if cable, plug or the
unit itself has been damaged by external
influences. Take the charger to the nearest
service centre.
 Never open the battery charger. If the
battery charger is defective, take it to a
service centre.
ARM3740Li