Errors And Possible Remedies; Automatic Time Limitation; Interior Lighting Does Not Work - ABATEC A2 Montageanleitung Und Bedienungsanleitung

5

Errors and possible remedies

5.1

Automatic time limitation

• The sauna control turns off after 6 / 12 hours of
continuous heating (depending on factory set-
ting).
• For continued operation press the START /
STOP 8 key.
5.2

Interior lighting does not work

• Turn off ON / OFF 1 key.
• Turn off main fuse of the sauna control in the
fuse box.
• Replace light bulb.
• Contact customer service or the electrical engi-
neer, if the interior light still does not work. (look
at part 1, chapter 6)
5.3 ERROR Display messages
The sauna control is not ready-to-operate:
1. Turn off main fuse of the sauna control in the
fuse box.
2. Contact customer service or the electrical engi-
neer.
3. Mark the device as "defective".
26
Operating instructions for the user - Figure 5
5 Errors and possible remedies
With the following display error messages 4 you
can inform customer service of possible errors/de-
fects.
The error messages of the display mean:
E-F1: Short-circuit or interrupted tempe
rature sensor line (white line)
E-24: Excessive temperature fuse defect,
or (red) cable to excessive
temperature fuse interrupted.
E-P1: Setting potentiometer for nominal
temperature defect.
E-51; E-52;
E-53: Key 7 or 8 blocked
LL: Temperature of interior
below 0°C
HH: temperature of interior
above 140°C