Pausing Operation For A Longer Time Period - ABATEC A2 Montageanleitung Und Bedienungsanleitung

3 Operation
3. Confirm the selected time with the START /
STOP 8 key.
The remaining time is shown in the display 4
with a flashing dot. (selected time = remaining
time until heater starts).
After expiration of the pre-section time the dis-
play 4 indicates depending on the device type
00.00 or the temperature measured in the area
of the temperature sensor.
4. Set the desired temperature with the rotary knob
TEMPERATURE 6 in the range of
50 - 125 degrees Celsius.
5. To exit:
5.1 Press START / STOP 8 key.
The sauna heater turns off.
The display indicates 00.00
The signal lamp 3 HEATING goes out.
The control is ready for entering a selected time
or ready for a restart.
5.2 Press ON / OFF 2 key.
The sauna control is turned off.
NOTE:
The time needed for warm-up until the set temperature
of the heater is reached varies, depending on size of
sauna and type of stove.
NOTE:
The temperature indication at the position of the tem-
perature sensor differs very significantly from that of
the temperature in the area of the sunbed.
Operating instructions for the user - Figure 5
4 Pausing operation for a longer
time period
Turn off main fuse of the sauna control in the fuse
box.
25