Connecting The Receiver - switel BCF268 Bedienungsanleitung

Connecting the receiver

Attention: Position the receiver with a minimum distance of 1 m to other electronic devices,
otherwise there is a risk of mutual disturbance.
Operating with a power adapter plug
Ensure you use the correct power adapter plug. The receiver must be connected by means
of the larger power adapter plug which has an output power of 500 mA.
Connect the cylindrical plug on the power adapter plug cable to the receiver's power supply socket
(9 V DC).
Connect the power adapter plug to a power outlet (230 V).
Operation with batteries or rechargeable batteries
Open the battery compartment on the rear side of the receiver. Loosen and remove the screw and
slide the battery compartment cover downwards.
Insert the battery pack or batteries paying attention to correct polarity. Refer to the diagrams in the bat-
tery compartment.
The receiver unit can be operated using 5 normal AA" batteries or rechargeable batteries of
the same type. Please remember that standard rechargeable batteries cannot be recharged
directly in the receiver. A commercially available charging unit is required to recharge bat-
teries.
Only special batteries can be recharged directly in the receiver. They are contained in the ma-
terial supplied. If you have any further queries, please contact your sales outlet.
Close the battery compartment, reinsert and retighten the screw.
The Power LED turns orange when the battery charge is too low.
Attaching the belt clip / wall mounting bracket
Slide the belt clip downwards on the back of the receiver until it audibly snaps into place. To remove it,
release the fit by pulling the belt clip out of the catch and sliding it upwards.
Wall installation
The belt clip is provided with a hole used for installing the unit on a wall.
Be careful not to drill into electrical lines or water pipes! Ensure that no lines or pipes are under
the required installation location!
Dowels and screws are not contained in the material supplied.
Drill a hole (diameter 5 mm) at the required position in the wall.
Insert a dowel (5 mm diameter) in the hole.
Insert a screw (4 mm diameter) in the dowel.
Leave approx. 3 mm from the head of the screw to the wall.
Guide the recess in the receiver over the screw head and pull the unit down gently.
Putting the Units into Operation
43