Connecting The Receiver - switel BCF800 Bedienungsanleitung

Connecting the receiver

Attention: Position the receiver with a minimum distance of 1 m to other electronic devices,
otherwise there is a risk of mutual disturbance.
Operating with a power adapter plug
Connect the receiver as illustrated in the diagram. For safety reasons, only use the power adapter plug
supplied.
Attention: Use the power adapter plug labelled Model No. CSD 0750150G with output data:
7.5 V, 150 mA for the receiver.
Operation with batteries or rechargeable batteries
Remove the belt clip, if necessary (see below).
Open the battery compartment on the rear side of the re-
ceiver.
Insert the rechargeable or standard batteries paying atten-
tion to correct polarity. Refer to the diagrams in the battery
compartment.
Close the battery compartment again.
Reattach the belt clip, if necessary.
The receiver can be operated with 4 AAA" batteries (not contained in the material supplied)
or with rechargeable batteries of the same type. Rechargeable batteries can be recharged di-
rectly in the receiver when it is inserted in the charging station.
Attention: Personal injury and/or equipment damage is possible!
Do not place the device in the charging station if standard batteries are installed.
There is a risk of the device exploding and/or becoming excessively hot.
If the battery power becomes too low, LEDs light up alternately. The batteries must be recharged/re-
placed.
Attaching/Detaching the belt clip / wall mounting bracket
Slide the belt clip downwards on the back of the receiver until it audibly snaps into place. To remove it,
release the fit by pulling the belt clip out of the catch and sliding it upwards.
Registering the receiver and transmitter / Establishing a connection
The receiver and transmitter are registered. If necessary, registration can also be completed manually:
1. Switch the transmitter and receiver on.
2. Press the
MENU
Connection LED flashes.
3. Press the Registration button on the transmitter briefly. The Connection LED also flashes.
When a connection is established, the image viewed by the lens appears in the display.
Mains power outlet
button on the receiver and keep it pressed until the
Putting the Units into Operation
41