Operating The Transmitter; Switching The Transmitter On/Off; Night Vision - switel BCF268 Bedienungsanleitung

Operating the Transmitter

4 Operating the Transmitter
Check the transmitter and receiver are working properly each time before the equipment is
put into operation.

Switching the transmitter on/off

1. Set the Power on/off switch to ON". The Power LED lights up green. The transmitter is now
ready to operate.
The power LED turns orange when the battery charge is too low.
2. Select CAMERA, AUTO or AV operating mode in order to transmit the noise and video signals
from the area being monitored or AV INPUT signals to the receiver.
3. Position the transmitter in a good position for the monitoring tasks required and align the lens to
the area to be monitored.
4. To switch the transmitter off, set the Power on/off switch to OFF".
Selecting the transmission mode
Select the operating mode required using the selection switch:
CAMERA − Audio and video signals from the area being monitored are transmitted continuously to the
receiver.
AUTO − Audio and video signals are only transmitted to the receiver when a specific noise level is ex-
ceeded.
AV − The transmitter transmits audio and video signals fed via the AV INPUT socket. These can be
signals from DVD players, cameras, etc. Plug the black jack plug on the audio/video cable in the AV
INPUT socket and the yellow, white and red phono plugs in the correspondingly coloured sockets in
the output unit. For further information, refer to the operating manual provided with the respective de-
vice.
Selecting a channel
Press the channel selection button to select the required channel A, B, C, or D. The channel cur-
rently selected is indicated by the corresponding LED.
The transmitter and receiver must be set to the same channel.

Night vision

The transmitter is equipped with 10 infra−red diodes. This enables the transmission of pictures from
areas which are not illuminated. The night vision function is activated automatically when the light
conditions make it necessary.
When the night vision function is activated, the screen display on the receiver turns to black
and white.
44