Getting Started; Important Safety Information - Plantronics S12 Bedienungsanleitung

UK
DIAGRAM KEY
HEADSET
1 Adjustable Headband
2 Headset Assembly
3 Clothing Clip
4 Headset Plug
5 Microphone Boom
6 Ear Cushion Assembly
7 Earloop
8 Pivot Ball Ring
9 Firefly™ In-Use Indicator
BASE FRONT
10 Headset Holder
11 Compatibility Slide Switch
12 S12 Amplifier

IMPORTANT SAFETY INFORMATION

PLEASE READ THE FOLLOWING INSTRUCTIONS BEFORE USE:
When using your telephone equipment these basic safety precautions should
be followed to reduce the risk of fire, electric shock, and injury to persons.
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the product. The symbol
dentifies and alerts the user to the presence of important operating and
service instructions.
3. Do not use this amplifier on one piece telephones where the key pad is
the handset.
4. Do not locate base unit near water, for example, near a bathtub, wash bowl,
kitchen sink, or laundry tub, in a wet basement or near a swimming pool.
7
13 Headset Indicator (Green LED)
14 Power Indicator (Amber LED)
15 Mute Indicator (Red LED)
16 Listen Volume Control
17 Mute Button
18 Headset/Handset Button
19 Transmit Volume Control
20 Transmit Volume Switch
21 Cord (Telephone to Amplifier)
BASE REAR
22 Headset Socket
23 Handset Socket
24 Telephone Base Socket
5. Do not place this product on an unstable cart, stand or table. The product may
fall, causing serious damage.
6. This product should never be placed near or over a radiator or heat register.
It should not be placed in a built-in installation unless proper ventilation
is provided.
7. Never push objects of any kind into this product as they may touch dangerous voltage
points or short out parts that could result in a risk of fire or electric shock. Never spill
liquid of any kind on the product.
8. To reduce the risk of electric shock, do not disassemble.
9. Keep all product cords and cables away from operating machinery.
10. Avoid using a telephone (other than a cordless type) during an electrical storm.
There may be a remote risk of electric shock from lightning.
11. Do not use the telephone to report a gas leak in the vicinity of the leak.
The S12 complies with the following EU directives:
89/336/EEC – The EMC directive
73/23/EEC – The low Voltage Directive

GETTING STARTED

INSTALL BATTERIES
Fig. A The batteries on your amplifier will need to be installed before you can use
your headset. You should disconnect the amplifier from your telephone before
doing this. To install the batteries, remove the silver cover on the top of the
amplifier. Remove the battery door. Put the batteries into the compartment
and replace the covers (Refer to Fig A on page 4). The amplifier has a low
battery warning light (14), if this is illuminated then you should replace the
batteries as soon as possible.
CONNECT THE AMPLIFIER
Fig. B Unplug your telephone handset cord from the telephone base.
Fig. C Plug your telephone handset cord into the S12 Amplifier Handset
Socket (23).
Connect the Cord (21) between the Telephone Base Socket (24) on
the S12 Amplifier (12) and your telephone base.
UK
8