Bresser TemeoTrend SQ Bedienungsanleitung Seite 23

Using the snooze function
1. If no button is pressed while the alarm is
sounding, the alarm automatically turns off.
Press the SNOOZE/LIGHT button when the alarm
is sounding so that the alarm is interrupted and
the snooze function is activated. The alarm
symbol will flash.
2. If the snooze function is activated, a four-
stage wake-up call takes place in a time period
interval of 5 minutes. The duration of the alarm
is approximately 120 seconds.
3. The snooze function can only be deactivated by
pressing the ALARM SET button (Fig. 1, 2).
Weather forecast
(Not applicable to TemeoTrend SQ/ Type. No. 70-04400)
The integrated barometer
atmospheric air pressure. Based on these
values, a forecast of the weather for the next 12-
24 hours will be created.
Pay attention: The accuracy of the weather
forecast is about 70-75%. The weather forecast
is always for the next 12-24 hours and does
not necessarily take into account the current
weather conditions.
Display of the channels
1. As standard, channel 1 appears on the
display. Press the CH + button (Fig. 1, 3) in the
display mode to switch between the individual
channels.
2. Press and hold down the CH+ button for
about 2 seconds to activate the automatic
channel-change display.
3. Press the CH+ button once again to return to
normal display mode.
Pay attention: With the automatic channel-
change display, the display automatically
switches between the three channels every 4
seconds.
registers the
Display of the current indoor and outdoor
temperature
1. Slide the °C/°F switch (Fig. 1, 6) to position
for the desired temperature unit (Celsius or
Fahrenheit).
2. The internal temperature appears in the
display on a permanent basis. The outside
temperature of the connected outside sensors
can be displayed separately or automatically
(read more about this in the previous chapter).
DE
GB
FR
NL
ES
IT
23