Bresser TemeoTrend SQ Bedienungsanleitung Seite 24

Pay attention: If a channel is allocated to an
external sensor, after a change of the channel
on the sensor, the RESET button (Figure 2,
13/ Fig. 3, 18) must be pressed. If no signal
is received for a channel, "—-" appears in the
display. In the case of receiver interference,
change the position of the weather station or
the outdoor sensor. Ensure that both devices
are located in the optimum operating range
of about 50 meters to each other. If several
attempts fail, remove the batteries from both
devices and initiate the setup again. Try to
establish in which position the weather station
receives the best signal strength.
Display and clear the max/min temperature
values
1. Press the MEM- button (Fig 1.4) in the display
mode. This will cause the device to display the
max/min values for the indoor and outdoor
temperature, as well as the date/time settings,
for around 5 seconds.
2. Press and hold down the MEM/- button for
about 3 seconds, to clear the stored max/min
temperature values.
24
Pay attention: When resetting the settings or
removing the batteries, all the stored settings
will be cleared!
Frost warning
1. If an outdoor temperature range of between
-2 °C and +3 °C (28 ° F and 37 ° F) is reached,
the symbol appears in the display and
flashes permanently.
2. The symbol is no longer visible if the outside
temperature range lies above the limit values.
Using the backlight
(Not applicable to TemeoTrend JC/ Type. No.
70-04404)
Press the SNOOZE/LIGHT button (Fig. 1a, 1),
to activate the backlight, for about 5 seconds.
Set the view angle
(Only TemeoTrend JC/ Art. No. 70-04404)
Use the < / > slide switch (21) to set a bet-
ter view angle for the liquid display:
If the clock is placed directly on a flat surface
with the table stand, choose the <
If the clock is mounted on the wall, choose the
< > position.
> position.