AEG HK654406FB Benutzerinformation Seite 16

16 www.aeg.com
Problem
comes on.
comes on.
and a number come on.
comes on.
7.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also
three digit letter code for the glass
ceramic (it is in the corner of the glass
Possible cause
The Child Safety Device or
the Lock function operates.
There is no cookware on the
zone.
The cookware is incorrect.
The diameter of the bottom
of the cookware is too small
for the zone.
The cookware does not cov-
er the cross / square.
There is an error in the hob.
There is an error in the hob
because a cookware boiled
dry. Automatic Switch Off
and the overheating protec-
tion for the zones operate.
surface) and an error message that
comes on. Make sure, you operated the
hob correctly. If not the servicing by a
service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the
Service Centre and conditions of
guarantee are in the guarantee booklet.
Remedy
Refer to "Daily use" chapter.
Put cookware on the zone.
Use the correct cookware.
Refer to "Hints and tips"
chapter.
Use cookware with correct
dimensions.
Refer to "Technical informa-
tion" chapter.
Cover the cross / square
fully.
Disconnect the hob from the
electrical supply for some
time. Disconnect the fuse
from the electrical system of
the house. Connect it again.
If comes on again, speak
to an Authorised Service
Centre.
Deactivate the hob. Remove
the hot cookware. After ap-
proximately 30 seconds, acti-
vate the zone again. If the
cookware was the problem,
the error message goes out.
Residual heat indicator can
stay on. Let the cookware
become sufficiently cool.
Check if your cookware is
compatible with the hob.
Refer to "Hints and tips"
chapter.