Starting Up; Filling The Stone Container - Sentiotec HOME-F45 Montage- Und Gebrauchsanweisung

Instructions for use for the user

5. Starting up

5.1. Filling the stone container

WARNING!
Risk of fire due to overheating
If the sauna heater is used without sauna stones, the cabin walls will
become extremely hot. This could cause fires.
● NEVER operate the sauna heater without the sauna stones.
The stone basket 1 can be mounted at
two different heights.
Position 2: fewer stones, shorter heating
time, energy saving
Position 3 (set at factory): more stones,
larger amount of water for pouring possible,
creating more steam, longer heating times
The amount of stones suited to your heater can be found in chapter 10. Tech-
nical data (see page 25).
1. Wash the stones thoroughly using water and a brush before use. Do not
use any cleaning additives.
2. Before filling the heater with the sauna stones, check them for foreign objects
and remove any remaining packaging.
3. Place the stones in the stone container and also between the heating rods.
Place sauna stones loosely so that air can flow through the gaps.
4. Do NOT allow the heating rods to make contact with one another.
5. Make sure that the sauna stones do not stick out over the edge of the stone
container.
p. 19/26
1
2
3
EN