RIKA Look RLU Montageanleitung Seite 18

Mounting
Set the wooden bench as desired. The holes are symmetrical, you
can turn around the bench and set the seat part right or left.
First, plug the plinth panel, then the 4 spacers on the preassembled
screws on the stove.
Fasten the parts with the enclosed threaded sleeves.
Lay the heat shield on the wooden bench, hole on hole.
Mounting support E15768
Insert the two „handles" in the top flue outlet so that the lower
bending faces outward.
Now insert the two spacers between them so that they engage with
the tabs into the slots.
Now the position of the two handles is fixed.
Put a stable rod or a square timber through the two openings. The
stove can now be lifted. A third person should lead the bottom of
the stove to find the correct position on the basement.
Note
Do not use round rods or tubes, only rods with a flat contact
surface. Risk of slipping! Pay attention to the simultaneous lifting.
Now unscrew the transportation construction from the stove.
#10
Note
Warning, the stove is no longer secured against tipping!
Lift the stove careful and set it on the bench with the threaded
sleeves into the holes.
Screw the hexagonal bolts and washers from the bottom into the
threaded sleeves. The stove is now secured. Attach the air intake
socket and the distance.
Insert the glass plate in the lower shelf to protect the wooden
surface. Put the quiver for the fire irons into the provided hole.
#8
#13
#25