Ayce KSE 40/2400 Originalbetriebsanleitung Seite 112

- Never try cutting through two logs at same time, only cut one log at a time.
- Do not bury guide bat nose or try plunge cut(boring into wood using guide bar nose)
- Watch for shifting of wood or other forces that may pinch chain.
- Use extreme caution when reentering a previous cut.
- Use low-kickback chain and guide bar supplied with this chain saw. Only replace these
parts with chains ad guide bar listed in this manual.
- Never use dull or loose chain, keep chain sharp with proper tension.
- Do not hand sharpen chain on automatic chain sharpening (fast sharp) models.
Always cut into the compression wood first until the cut starts to close. Always make the
compression cut beneath if the log or limb is suspended from one end, and on top if it is
supported at both ends, cut from the other side towards the compression cut, make a habit
of using a wedge to prevent the compression cut jamming tight on the chainsaw blade.
• During use of the chainsaw, the extension cord will continually be pulled as you move from
one area to another.
• A cord retention hook has been provided on the housing of the chainsaw to assist in
fig.13