Scope Of Delivery; Instructions For Use; Preparation For Use - Ottobock 491S32 Gebrauchsanweisung

CAUTION
Improper adjustment
Crushing or pinching due to adjustments which are too tight
► Do not pinch the user when sliding in the product.
CAUTION
Collisions while driving
Crushing or pinching by the tray
► Please note that the user may be crushed by the tray in the event of a collision. Avoid colli­
sions.
CAUTION
Driving with objects on the tray top
Burns or other injuries caused by objects falling off the tray
► Remove all objects from the tray top prior to travelling.
NOTICE
Improper use
Damage to the product caused by incorrect use
► Ensure that the user does not travel with the tray folded down to the side.
► Do not pull the product too far out from the receiver tube.
Do not place any hot objects on the tray top.
►
► Do not overload the tray top. See the section "Technical Data" for the maximum permissible
load capacity.

5 Scope of Delivery

The scope of delivery includes:
• 491S32=ST032 Tray (large; in 491S32=SK130 Assembly)
• 491S32=ST031 Tray (small; in 491S32=SK030 and 491S55=SK020 Assembly)
• 491S32=ST133 Tray (XL; in 491S32=SK230 Assembly)
• 491S32=SK131 Adapter (in 491S32=SK030, 491S32=SK130 and 491S32=SK230 Assembly)
• 491S55=SK022 Adapter (in 491S55=SK020 Assembly)
•

Instructions for use

6 Preparation for Use

6.1 Assembly
INFORMATION
Note that for the 491S32=SK230 Assembly the drill holes to secure the tray top need to be cre­
ated. To do this, refer to step 6.
The tray is fastened to the side opposite the control panel. Take note of the user's requirements
and the technical conditions (size, adapter, installation side).
1) Unscrew the armrest from the armrest adapter (see fig. 1).
2) Place the receiver tube on the armrest (see fig. 2, item 1). The screw with the star-shaped
handle must face outwards after assembly (see fig. 3, item 1).
3) Reinstall the armrest (see fig. 4).
10