Mounting Ktx Transmitters; Mounting Onto Antc Klinger Magnetic Level Gauge Chamber; Number Of Recommended Mounting Clips - TC KEMA 04ATEX1232 X Betriebsanleitung

Mounting KTX Transmitters

Example of mounting onto the TC KLINGER Level gauge chamber
The description provided here is an specific example the actual mounting method will depend on
the specification of components supplied and location specific requirements.
Please also refer to the assembly and operating instructions of the Level gauge.
Mounting onto a TC Klinger
Magnetic Level gauge
Use the supplied mounting clips to fasten the KTX
Transmitter to the level gauge chamber.
Depending on the magnet system, the distance between the level
gauge chamber and the KTX Transmitter tube should not exceed
8 mm.
When the KTX transmitter is used as a distance measuring
system, the actuator(magnet) must not be allowed to scrape along
the transmitter tube.
The Transmitter tube must not be modified in any way as this will
invalidate the certification
Please note the material pairings.
When mounting the transmitter in position sensing applications
the use of non-magnetic materials is recommended.
Number of recommended mounting brackets or tightening straps
Distance centre-to-centre up to
Distance centre-to-centre above 1000mm add 1 bracket for every additional 1000mm
The brackets must be fitted at equal distances along the entire length of the tube.
5 /30
1000mm 2 brackets
Rev 8
4
5
6
7
1 KTX Sensor
2 Fixing straps
3 Magnetic Display
4 Fixing screw
5 Spacer
6 Mounting clip
7 Mounting Plate
07/05/2014
1
2
3