Installation Instructions; Important Information; Scope Of Delivery; Important - Garantia 202040 Einbauanleitung

1.1

Scope of delivery



Installation instructions


Drinking water intake module including the following parts:

Changeover valve, 1''

Float valve, ¾"

Domestic water works, fitted on pump console

Floating switch with 20 m connection cable and adaptor plug

Special DN 70 seal with emergency overflow and odour trap

Round lid to cover inside

Fastening kit
1.2

Important


Read and comply with the following information and explanations carefully before installing and
commissioning!

Do not plug in the mains plug until you have

correctly fastened the GARANTIA drinking water intake module and

checked the water connections (inlet, overflow and extractor) for any leaks.

We recommend bringing in a specialist in the sanitary or installation trade to install the module.

To avoid overflowing cellars, which can be caused by improper handling or an act of God, it is
recommended to install the module in a cellar which has a drain in the floor.

The inside of the container for the drinking water intake module should be clean (important if the
system has been stored for a period of time or if there is any construction dust). There may also
be a small volume of residual water in the container from the final inspection. The container must
be rinsed before commissioning.

Use the sealing Teflon tape and installation hemp to seal the screw connections.

All inlet lines, drainage lines and power supply lines must be laid depressurised and without strain
and must be connected in a freely accessible manner.

When undertaking these installation steps, remember that the flood level is the same as the street
level. If you have any questions, contact your local building authorities.

You cannot make a warranty claim if you do not comply with these instructions!

The corresponding earthing type plugs should be disconnected from the mains!

The mains plug must be freely accessible!
1.3

Area of application

The device is approved for operating

with 230 volt 50 Hz AC voltage and

for controlling rainwater harvesting systems
1.4

Responsibility

The operator assumes full responsibility for all measures

to ensure correct installation and

to prevent dangers due to improper operation
NO LIABILITY WILL BE ACCEPTED FOR COSTS INCURRED DUE TO IMPROPER OPERATION OR
info@garantia.eu
www.garantia.eu

1. Important information

INSTALLATION.
11 / 27