Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
the Negative (-) output terminal and the work cable to
the Positive (+) terminal. This is the typical
configuration for Flux Cored Welding (FCAW).
Controls and Operational Features of
the MiniMagster 1501 and 1501S
1.
Power Switch: Turns the machine on/off. Switching
on is indicated by lighting up of the switch button.
2.
WFS (Wire Feed Speed) Knob: 10-position scale
enables stepless WFS control in a range of 0 -
18.0m/min.
3.
Welding Voltage Changing Switche: enables four
values of welding voltage step selection: MIN1,
MIN2, MAX1 and MAX2.
WARNING
It is not allowed changing the welding voltage
range during welding process! It may damage
the switch.
Thermal Protection Indicator: The lamp indicates
4.
overheating of the machine.
5.
Welding Gun: Supplies welding voltage and
shielding gas and feeds electrode wire.
6.
Ground Cable with the Work Clamp.
Rear Panel of the MiniMagster 1501
1.
Input Power Cord with the Plug.
2.
Hose: For shielding gas connecting.
3.
Cooling Fun Holes: Don't cover!
4.
Shelf: For placing the gas cylinder .
After installation, protect the shielding gas cylinder
from overturn with the chain. Don't place any gas
cylinder over 10 l – it can cause overturning the
welder.
Rear Panel of the MiniMagster 1501S
1.
230V Input Power Cord with the Plug.
2.
400V Input Power Cord with the Plug.
3.
Hose: For shielding gas connecting.
4.
Cooling Fun Holes: Don't cover!
5.
Shelf : For placing the gas cylinder .
After installation, protect the shielding gas cylinder
from overturn with the chain. Don't place gas cy-
linder over 10 l – it can cause overturning the
welder.
6.
Power Supply Change Switch
It is not allowed changing the welding voltage
range during welding process! It may damage
the switch.
Final Actions
Connect the work cable to the work with the work
clamp.
Connect the gas cylinder to the gas input through the
gas regulator.
Insert the plug of the power input cord into the mains
power socket.
Switch on the welder with the power switch. Switching
on is indicated by lighting up of the power indicator.
Based on the seam kind, join type and material
thickness of the work piece, chose correct welding
settings with the welding voltage switch and WFS
control.
Obeying the appropriate regulations, you can begin to
weld.
MIG/MAG Welding
The MIG/MAG Welding method requires adjusting only
two parameters:
9
WARNING
WARNING
WARNING
Werbung
Inhaltsverzeichnis
