Asus Pundit P1-AH1 Schnellinstallationsanleitung Seite 8

Reinstalling the storage drive assembly
Before reinstalling the storage drive assembly, connect the IDE / SATA and
power plugs to the IDE / SATA and power connectors at the back of the
drives.
1. Connect the black plug of the IDE cable to the optical drive, then the
gray plug to the hard disk drive. If you have the SATA HDD, connect
the SATA cable to the SATA HD.
2. Connect the 4-pin power plugs to the power connectors at the back
of the drives.
3. Install the storage drive assembly to the chassis.
4. Secure the storage drive assembly with three screws.
Installing the foot stand
1. Match the foot stand hooks to
the holes on the chassis.
To remove the foot stand, lift the lock, then slightly push the foot stand to
the direction of the rear panel until it disengages from the chassis.
Reinstalling the front panel cover
Refer to the section of Removing the front panel cover and follow the
instructions in reverse.
Reinstalling the cover
Refer to the section of Removing the cover and follow the instructions in
reverse.
8
3
2. Pull the foot stand to the
direction of the arrow until the
lock clicks in place.
Quick installation guide Quick installation guide
4