Yaesu G-1000DXC Bedienungsanleitung Seite 7

Controller Rear Panel
T 1A L
EXT CONTROL Connector
This 6-pin mini-DIN connector is used for connec-
tion to the optional GS-232A Computer Control
Unit.
SELECT SWITCH
Set this switch to the "
ADJ. MODE
calibrating the internal adjustments of the control-
ler. During normal operation, however, set this switch
to the " OPERATION MODE
FULL SCALE ADJ Potentiometer
This control calibrates the maximum rotation angle
(range) of the azimuth indicating needle to match
the maximum angle of the rotator.
OVERLAP LED ADJ Potentiometer
This control calibrates the OVERLAP Indicator to
match the azimuth indicating needle.
PRESET ADJ ( A & B ) Potentiometers
These controls calibrate the angle of the PRESET
control on the front panel to match the azimuth indi-
cating needle. Pot. A should be adjusted only near
the 0° position, and Pot. B only near the 450° posi-
tion.
G-1000DXC/-2800DXC User Manual
OPERATION ADJ. MODE FULL
MODE SCA LE
EXT SELECT ADJ
CONTROL SWITCH
INPUT AC220 - 240V~
0 .7 A 50 - 6 0Hz
SER. NO. 000000000
" position while
" position.
OVERLAP A B OUT VOL
LED A DJ ADJ
PRESET
ADJ
OUT VOL ADJ Potentiometer
This control presets the voltage range at pin 4 of the
6-pin mini-DIN EXT CONTROL Connector, for
calibration of the A-to-D converter on the (optional)
GS-232A Computer Control Unit.
Rotator Control Cable Jack
The supplied control cable from the rotator connects
to this 6-pin jack.
FUSE Holder
This holder requires a 1-A fuse for AC voltage from
220 to 240V. If the fuse is blown, replace only with
a fuse of the same rating. See your Yaesu dealer for
a suitable replacement.
AC Cable
Connect this cable to the AC 220 - 240V wall outlet.
The types of antennas that can be attached to this prod-
Page 5