Yaesu G-1000DXC Bedienungsanleitung Seite 5

Safe and Correct Use of the Equipment
When installing this product, take care
not to jam your fingers between parts or
cut fingers on edges of parts.
If the condition of the equipment is ab-
normal such as emitting smoke or an
unusual smell, continuing to use the
equipment may result in fire or malfunc-
tion.
In such cases, turn off the power immediately
and unplug from the power socket.
After checking that the equipment is no longer
emitting the smoke or unusual smell, return the
product to the vendor or to your nearest Yaesu
Musen office or service center for repair.
In the event of foreign material getting
inside the controller, turn off the power
immediately and unplug from the power
socket.
Continuing to use the product in this condition
can result in fire or malfunction.
Do not use the product with a power sup-
ply voltage other than the specified volt-
age as this can cause fire or electric
shock.
In the product is to remain unused for a
long period of time, unplug the AC power
cable from the AC wall outlet and Rota-
tor Control Cable from the jack for safety.
Do not operate continuously for more
than 3 minutes.
The equipment can be operated for up to 5 min-
utes but operation must be halted and the motor
rested for at least 15 minutes afterwards.
There are no serviceable parts inside the
rotator or controller; therefore, never
open these units.
G-1000DXC/-2800DXC User Manual
Caution
Do not place the controller in an unstable
position such as on an unsteady or slop-
ing surface as this can cause the con-
troller to fall or tip over causing injury.
Do not place heavy objects on the power
cable and do not excessively bend or
pull the cable.
Damage to the power cable can cause fire or
malfunction.
Do not place the controller in direct sun-
light or close to heaters as this can cause
the box to distort or discolor.
Do not place the controller in humid or
dusty environments as this can cause
fire or malfunction.
Do not place the controller in enclosed
or poorly ventilated positions such as
in a bookshelf as this can cause fire or
faults.
Do not place the controller on carpet or
bedding as this can cause heat to build
up internally resulting in fire.
Do not place heavy objects on top of the
controller as this can cause the control-
ler to fall or tip over causing injury.
Do not place small metal objects such
as paper clips on top of the controller as
these can fall into the controller caus-
ing fire or malfunction.
Do not wipe the controller with solvents
such as thinner or benzene as this can
cause the box to distort or discolor.
To clean the controller, gently wipe with a cloth
moistened with a neutral detergent and clean off
with a dry cloth.
Do not turn on the power supply until
rotator and controller setup is complete.
Page 3