Soba RD410 Gebrauchsanleitung Seite 7

RD410 STEAM-CLEANER
Refilling Your RD410 with Water
1. Disconnect Electrical Power Cord from wall outlet.
2. Depress and hold the hand grip steam trigger to ensure that any remaining
pressure in the boiler has been released.
3. Carefully loosen the safety/filler cap by turning counter clockwise. Any residual
steam will be released below the safety/filler cap if the tank has not been
completely vented. When the hissing stops and the last of the steam has been
released, remove the filler cap.
CAUTION: Allow unit to cool down for 5 minutes. Escaping steam can cause
scalding.
4. Refill water tank with water using the filling funnel.
5. Firmly screw the safety/filler cap back onto the unit by turning clockwise.
6. Connect power cord to the wall outlet.
Using Your RD410 with Floor Brush
1. Connect one of the extension tubes to the hand grip on the flexible steam hose.
To attach the extension tubes one onto the other or onto the hand grip, press the
locking button ensuring that it fits into the hole (see illustrations.) To disconnect,
repeat the operation by pressing the locking button and pulling the two sections
apart.
Security button
NOTE: Fit floor brush with the angle adapter on to the extension tube.
2. If the angle adapter is not attached to the floor brush, hold the brush with its
bristles up in your left hand. With the angle adapter pointing downward, insert it
into the hole in the back of the brush, then turn the angle adapter 180°.
3. Insert the electrical power cord into the wall outlet. Heating time is approximately
3–5 minutes with cold water. Filling the steam generator with hot water will
shorten heat up time.
Handle
7
Security button
Extension tubes
INSTRUCTIONS