Putting Into Operation - easy Maxx JS-HH12A Gebrauchsanleitung

EN
3. Our thinning recommendation:
Coating material
Paints and varnishes containing solvents,
latex paint
Paints and varnishes containing water
Wood preservatives, glazes, oils, etc.

Putting Into Operation

CAUTION!
• Connect the device to a properly installed plug socket. The plug socket must also
be readily accessible after connection. The mains voltage must match the voltage
indicated on the rating plate of the device.
• Always switch off the device and pull the mains plug out of the plug socket when you
– remove / attach the paint container,
– replace the spray nozzles,
– adjust the paint jet.
• Make sure that the spray trigger is not pressed when you connect the device to a plug
socket or regulate the amount of paint!
• Never use the device with an empty paint container.
• Do not overfi ll the paint container! Note the markings denoting the fi ll level on the
container.
1. Unscrew the paint container (7) and align the paint intake pipe by turning it to the front
or back as required:
28
• This device generates a volume of up to 87.13 dB. For
this reason, wear suitable hearing protection! For your
own safety, also wear breathing protection, safety gog-
gles and work gloves when handling the device.
A. If you are working on fl at, horizontal objects, align the
paint intake pipe to the front.
Dilution
approx. 5-20%
approx. 5-10 %
Dilution not required