Autotek TransAm TA 4150 Bedienungsanleitung Seite 11

FIGURES
(P. 28-30)
CONNECTIONS AND CONTROLLERS (FIG. 1)
(1) High Level inputs CH3&4
(2) High Pass filter controller CH3&4
(3) Selector FULL / LPF (Low Pass) / HPF (High Pass) CH3&4
(4) Low Pass filter controller rear CH3&4
(5) Selector for the stage-to-stage enhancement of the bass level CH3&4
(6) Gain level controller CH3&4
(7) Audio signal inputs CH3&4 + CH1&2
(8) Gain level controller Front CH1&2
(9) Selector FULL / HPF (High Pass) CH1&2
(10) High Pass filter controller CH1&2
(11) PROTECT-LED and POWER-LED
(12) High Level inputs CH3&4
POWER SUPPLY AND TURN ON CONNECTION (FIG. 2)
(1) GND terminal for the ground
(2) REM terminal for the turn on connection
(3) +12 V terminal for the positive-connection of the battery
(4) Vehicle's battery
(5) In-Line Fuse (not included in the scope of delivery)
(6) Turn on wire from the head unit or the electrical antenna
(7) Fuse(s)
4-CHANNEL OPERATION STEREO (FIG. 3)
If you want to run the amplifier with the 4 line output channels* from the head unit to drive 4 loudspeakers front
and rear in stereo, connect the following setup:
(1) To the head unit, line output rear right
(2) To the head unit, line output rear left
(3) To the head unit, line output front right
(4) To the head unit, line output front left
(5) Loudspeaker rear right
(6) Loudspeaker rear left
(7) Loudspeaker front right
(8) Loudspeaker front left
3-CHANNEL OPERATION STEREO & MONO (FIG. 4)
If you want to run the amplifier with the 4 line output channels* from the head unit to drive a pair of loudspeakers
and a subwoofer, connect the following setup:
(1) To the head unit, line output rear right or subwoofer output
(2) To the head unit, line output rear left or subwoofer output
(3) To the head unit, line output front right
(4) To the head unit, line output front left
(5) Loudspeaker front left
(6) Loudspeaker front right
(7) Subwoofer
* If your head unit only have 2 output channels, use commercially available Y-adapters for splitting the signal.
But then the FADER function of the head unit does not work anymore.
IMPORTANT!
Always observe the correct polarity of all connections!
11