Replacing The Fuse; Maintenance / Care - Würth POWER START POWER START WPS 12-700 Originalbetriebsanleitung

Other functions
Connecting cable device/cigarette
lighter
The supplied connecting cable has two functions:
Use the device as a data memory when
you change the battery of your vehicle.
▸
Connect the Power Start with the connection ca-
ble to the vehicle's cigarette lighter before you
remove the battery.
Note
In some vehicles, the ignition has to be
switched on to provide a current connec-
tion with the cigarette lighter.
Charge the Power Start via the ciga-
rette lighter.
Attention !
This function is only available for WPS 12-700
and WPS 12-900!
▸
Connect the Power Start with the cigarette lighter.
Note
This function is especially intended for
service vehicles that are in use often.
Indicator to determine the on-board
voltage (only for WPS 1224-700 and
WPS 1224-900)
▸
Set the operating switch [3] to the "0" position.
▸
Connect the battery terminals [9] with the plus
and negative terminal of the vehicle battery.
The vehicle battery voltage is shown on the
3
display [6].
When the displayed value is larger than 15 V, then
an on-board voltage of 24 V is present.
When the value is smaller than 15V, checking the
on-board voltage according to the manufacturer
information is required.
18

Replacing the fuse

Risk of electric shock
Switch the device off before
¾
changing a fuse.
Disconnect the device from other
¾
devices.
▸
Switch off the device using the operating
switch [3].
▸
Disconnect the device from all other devices.
▸
Let the fuse cool down completely (about 5 minutes).
▸
To open the fuse holder [2] , remove the cover.
▸
Loosen the two nuts and the bolts that attach the
fuse on the positive cable.
▸
Remove the old fuse and insert a fuse of the same
type (see Technical Specifications).
▸
Attach the fuse with the two nuts and bolts.
▸
Attach the cover again on the fuse-holder.

Maintenance / Care

WARNING !
Risk of fire or electric shock
Disconnect the device from the
¾
power supply, prior to performing
maintenance or repair work.
▸
Charge the device permanently when not in use
▸
The Power Start can be connected at all times to
the automatic charger with no risk of damage.
▸
Protect the device against humidity and moisture.
▸
Clean the device only by using a clean, dry cloth.
▸
Store the device in an upright position in a cov-
ered, cool and dry place.
▸
Check the unit before each use and every
30 days for damage.
DANGER !