Laser Beam Adjustment - Neolt Electro SUPER trim 340 Anwenderhandbuch

USE

LASER beam adjustment

As the machine is factory adjusted and calibrated, no further adjustments are needed.
In case the LASER beam should be re-adjusted along the cutting line, operate as follows:
•
Switch off the machine and disconnect it from the mains.
•
Remove the Plexiglas cover
•
Remove the metal sheet covering the LASER beam emitter
•
Adjust the plate holding the emitter and align it with the cutting line
•
After having adjusted the direction of the LASER beam, screw again the metal sheet
covering the emitter, while adjusting it in order to have the beam directed only along the
cutting line.
As there are two LASER emitters, they must be aligned both.
I
Electro SUPER trim
I
.
L
NEOLT
6.1.6
L
.
6-5