Neolt Electro SUPER trim 340 Anwenderhandbuch Seite 85

USE
•
Place the media to be cut on the
insertion table, and size the cut by
means of the millimetres rules
the table. In case the media carries
cutting marks, the LASER tracer can
be used to position the material
along the cutting line.
•
Once the media to be cut is properly set, lock it with the clamping bar, pressing the
keyboard closure key
In order to perform the cut, the machine must comply with two conditions:
The emergency button
The sheet clamping bar
•
The material can be trimmed by performing a cut on both directions, depending
on the position of the carriage, and pressing the proper key on the keyboard.
D
E
or the footswitch
B
must be unlocked,
E
must be down.
E
Electro SUPER trim
D
on
F
F
NEOLT
6-2