Control Panel Functions - NATURAL CHLOR SMC20 Handbuch Zur Installation Und Wartung

5. EXPLANATIONS OF FUNCTIONS OF POWER
SUPPLY
The «Natural Chlor» chlorinator is fitted with sophisticated electronic
diagnostic system to maximize the life of the electrolytic cell. This system
incorporates an easily - understood LED display panel, indicating the action to be
taken at all times.
A summary of the action to be taken whenever any of the lights on the
casing control panel are on is given below.
1) Single press of the button decreases chlorine (Cl
10%. In order to turn OFF the chlorinator it is necessary to press the
button several times to make sure all
are OFF.
Note:The chlorinator produces always to 100% When you press the
buttom what you do is decrease the time of chlorine production no the
quantity of chlorine.
Low Salt (Nacl) Warning indicator
2)
increased to 5000 - 6000 ppm to satisfy chlorine production. If the
light flashes, the level of salt is below the minimum, the chlorinator will
turn off slowly automatically.
Chlorine Production Indicators
3)
indicator corresponds to 10% of Cl
High Salt (Nacl) Warning indicator.
4)
light will go on- add fresh water. If light is flashing the chlorinator will
shortly turn off automatically as salt levels exceed maximum. Salt
concentration must be decreased to 5000 - 6000 ppm.
Chlorine Production Indicators
. Salt concentration should be
. There are 10 indicators. Each
production.
2
When the salt level is high this
24
) production by
2