Technics SB-G90 Bedienungsanleitung Seite 12

Placing the speakers using the spikes
The spikes may enhance the audio quality.
≥ Panasonic is not responsible for any accidents or damage caused by improper assembly or handling of the product. Do
not attach the accessories in any other way than instructed in this Owner's Manual.
≥ Each speaker has a mass of approximately 32 kg (71 lbs). When tilting the speakers to attach the spikes, ensure that the
work is done by at least two people. When attaching the spikes, exercise caution to avoid catching your fingers or toes
between the speakers and floor or tipping the speakers over. In addition, ensure that you spread a thick mat or similar item
on the side of the floor where you will be tilting the speakers to prevent damage to the floor.
≥ Since each spike supports a mass of at least approximately 8 kg (17.6 lbs), the spikes may leave marks and indentations
on the installation location. To prevent the spikes from damaging the area, use the supplied spike shoes or purchase spike
shoes with large contact surfaces and adequate strength.
≥ Moving the speakers with the spikes attached may cause damage to the floor. Before changing the installation location,
remove the spikes.
To avoid floor damage, have two thick mats (or similar) available. Place them in the unpacking location and the installation
location in advance.
1 Place the speaker vertically on a thick mat (or similar).
2 Remove the protective bags (2 pcs) and the cardboard covering the speaker.
3 Carry the speaker to the installation location while tilting it forward, and place it on a thick mat (or similar).
Hold the speaker so that your
hands do not touch the
speaker unit.
12 (12)