Omni Bead Ruptor 4 Benutzerhandbuch Seite 8

1.
Turn unit off and unplug
power cord.
1.
Turn unit off and unplug the
power cord.
4.
Secure the new neck gasket
using the restriction tie with the
clamp positioned toward the
bottom of the instrument.
Tighten central screw.
Changing the Tube Holder
2.
Use the supplied 3 mm
allen wrench to loosen tube
carriage holder screw
Changing the Neck Gasket
2.
Use the supplied 3 mm allen
wrench to loosen the central
screw and remove restriction tie
and old neck gasket.
5.
Use the supplied 3 mm allen
wrench to tighten the central
screw and secure the tube
carriage.
3.
Use the supplied 3 mm allen
wrench to tighten tube
carriage holder screw
3.
Slide the new neck gasket onto
the pivot shaft and housing