Profitech Diamant TC 180 Betriebsanleitung Seite 35

L CUTS
L cuts are cuts in which a (rectangular) part of the tile is cut out. For this, it is necessary to
make two separate cuts.
NOTE: Only cut across on the underside of the material.
1. Use a pencil or marker pen to draw
the cutting line.
2. Remove the angle guide.
3. Position the cutting guide at the
desired distance from the cutting
disc and secure it in place.
4. Place the material on the table.
5. Before switching the machine on,
ensure that the material is not tou-
ching the disc.
6. Switch the machine on.
7. Wait until the disc has reached its
full rotational speed and is wet
before starting to cut.
8. Hold the material close to the
cutting aid and guide it towards the
cutting disk.
9. Cut to the desired length.
10. Switch the machine off and wait until the cutting disc is no longer turning before
removing the material. .....
11. Turn the material, adjust the cutting aid and make the second cut along the marking.
This time, cut over the first line slightly, and the piece you have cut should detach.
12. Switch the machine off and wait until the cutting disc is no longer turning before
removing the material.
35