mbas Discman 4 Betriebsanleitung Seite 38

The slower you move the device forward, the finer the surface!
After each ski or snowboard change, you must switch off the edge tuner and turn back the grinding disc
with the knurled nut (in
controlled way when switched on.
For consistently good tuning quality, always remove the swarf that occurs after base edge grinding!
38
38
 When tuning the base edge, place your hand on the base edge
tuning attachment as shown to ensure that the base edged is
ground evenly.
Make sure that the Discman does not tilt when tuning the
base edge!
Ensure that the ventilation grilles are not covered during
grinding!
direction) so that the Discman does not grind the steel edge in an un-
Discman 2