Special Functions; Program Selection; Commissioning; Factory Settings - BADU BNR 300 Montage & Betriebsanleitung

6. Special functions

6.1. Program selection

The suitable hydraulic variant for the specifi c application is selected and set here (see "B.6.
Hydraulic variants" on page 7). The associated diagram is displayed after pressing "Info".
Setting range: 1 - 6/Default: 1
Normally the program selection is made only once during initial commissioning by
the specialist. Incorrect program selection can lead to unpredictable errors.

6.2. Commissioning

Starting the commissioning help guides you through the basic settings necessary for commissio-
ning in the correct order and provides brief descriptions of each parameter in the display.
Pressing the "esc" key takes you back to the previous value so you can look at the selected
setting again or adjust it if desired. Pressing the "esc" key more than once takes you back to the
selection mode, thus cancelling the commissioning help. (See also "E.2. Commissioning help" on
page 13).
May only be started by a specialist during commissioning! Observe the expla-
nations for the individual parameters in these instructions and check whether
further settings are necessary for your application.

6.3. Factory settings

All of the settings that have been made can be reset, thus returning the controller to its delivery
state.
The entire parametrisation, analyses etc. of the controller will be lost irrevo-
cably. The controller must then be commissioned once again.
Special functions
The menu "7. Special functions" is used to set
basic items and expand functions.
The menu is closed by pressing the "esc" key or
selecting "Exit special functions".
Other than the time, all settings may
only be made by a specialist.
23