Settings; Regulation; Regulation Mode; Additional Relay - BADU BNR 300 Montage & Betriebsanleitung

4. Settings

The menu numbering can alter depending on the selection of hydraulic variant
(see "7.1. Program selection" on page 26).

4.1. Regulation

Here the relay for the regulation can be specifi ed. There are two relays available. The relay not
being used can be used as an additional relay, see 4.3 Additional relay.
Setting range: R1, R3/Default: R1

4.2. Regulation mode

If programmes 5 or 6 are selected, the regulation mode is set here.
Setting range: Fill, Drain/Default: Fill

4.3. Additional relay

The settings for the additional relay can be set here.
4.3.1. Additional relay
In regulation mode the additional relay switches parallel to the regulation relay. A temporal dry
run protection may also be set. In safety mode the relay switches following the end of the safety
time or for other safety functions. An alarm signal can also be set in addition to the switching
mode.
Setting range: Off, Regulation, Safety/Default: Off

4.3.2. Safety mode

„Continuous" and „impulse" are the modes available.
The "continuous" mode can be used to open a pool cover to prevent it from damage if the water
level drops to low, for example. Another use would be to "drain". The "Impulse" mode can be
used to control an acoustic warning signal, for example.
Setting range: Continuous, Impulse/Default: Continuous

4.3.3. Impulse on-time

Impulse on-time in seconds for the additional relay in safety operation and impulse mode.
Setting range: 3 ... 30/Default: 10
18
Settings
The necessary basic settings required for the con-
trol function are made in the menu "5. Settings".
This does not under any circumstan-
ces replace the safety facilities to be
provided by the customer!
The menu is closed by pressing the "esc" key or
selecting "Exit settings".