Manual Regeneration; Quick Cycling The Control - Pentair 368 Bedienungsanleitung

Manual Regeneration

Quick Cycling the Control

14
Rev B
Delayed Regeneration: Press and release to program a delayed
regeneration. The system will regenerate at the next Time of Regeneration
(2:00). Repeat procedure to disable the Delayed Regen. Regen dot blinks
when delayed regeneration is on.
Immediate Regeneration: Press and hold the f or 3 seconds to initiate
an immediate regeneration. The control will display a cascading symbol
(- -) as it cycles to backwash. The control will proceed through a complete
regeneration.
Quick Cycling: Press and hold for three seconds to initiate an
immediate regeneration. The control will cycle to the backwash cycle.
1. Press and release the to display "C 1"
2. S imultaneously press then release and to move the control to the
next cycle.
3. P ress and release the to display "- -" or the "C#".
Continued pressing of will switch the display between "- -"
and "C#"."
4. Repeat steps 2 and 3 to cycle through each position.
Quick Cycle to Service Position: Simultaneously press and and
hold for 3 seconds during any regeneration cycle. The control will skip the
remaining regeneration cycles and return to the service position. The Time of
Day will be displayed when the control reaches the service position.
Pentair Residential Filtration, LLC