EDNord AutoUltima Pro Bedienungsanleitung Seite 7

AutoUltima Pro – Load Film
IF POSSIBLE, ALWAYS LOAD FILM BEFORE RUNNING COMPLETELY OUT.
Heat
Button
Cut laminating film as indicated. If
1
film is not present see next page.
Open all 4 "EZ" Load levers and
2
remove film.
3 Remove Idler Bar Assembly, then
press "Heat" button.
Insert new film, overlap film on
4
Heat Shoe.
Note: Match colours of film core
ends to EZ Load Levers.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 9633 3500
5
6
7
Screen
Start Stop
Enter
G
Insert and lock Idler Bar Assembly,
then close 4 EZ Load levers.
Press feed switch (forward) and
hold until wrinkle-free lamination.
Close top.
Scroll up or down to select film
thickness. Press "Enter" to
confirm. Press "Start" to resume
lamination. To reset film thickness,
hold enter button for 5 seconds,
select film thickness then press
"Enter".
7