Centronic UnitControl UCR520 Montage- Und Betriebsanleitung Seite 19

Note
The device can be set as a drive controller or group controller using the
encoding switch on the back.
Connection as a drive controller
Caution
• Risk of injury by electric shock.
• Terminal connections must be carried out by an authorised electri-
cian!
• If more than one drive is controlled using the UCR520, the drives
must be decoupled by relay controls. This decoupling is not applica-
ble to Becker drives with electronic limit stop.
Always observe the switched current of the device.
1. Remove the protective caps.
2. Connect the power supply unit to the UCR520 as follows:
3. Put the protective caps back on the power supply unit.
4. Fix the power supply unit in the box.
5. Put the operating device in the frame and plug it into the power supply unit.
de
en
fr
nl
19