Herunterladen Inhalt Inhalt Diese Seite drucken

Warranty - havel therm SH-2,0 Montage- Und Bedienungsanleitung

Einschraubheizkörpern sh-serie
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
10
heating of the appliance must be monitored. During the heating process, the expanded
water produced in the interior boiler must drip from the safety valve in the case of a pres-
surized connection and from the overflow mixing faucet in the case of an unpressurized
connection. The automatic cut-out function of the thermostat must be checked.
When repair becomes necessary, only use original replacement parts!
CONSIDERATIONS FOR USE
1. Depending on the lime content of the water and the operating conditions, it may
be necessary to free the heating elements from boiler scale at regular intervals.
It is recommendable to install softening equipment or a temperature reduction, as
described in the following. Please note that damage to the heating element caused
by calcification does not represent a warranty situation for damages or consequential
damages.
2. The container water temperature can be continuously adjusted using the temperature
selector to match your warm water requirements. The maximum temperature setting
is ca. 75°C. The minimum temperature setting is ca. 9°C and thus also serves as
protection against freezing. The differential gap amounts to ca. 10°C. So, when set to
75°C, the temperature will sink to ca. 65°C, before the heating element is switched
on again. To prevent overly rapid calcification of the heating element, we recommend
setting the temperature to below 60°C. This roughly matches the position of the
temperature control shown in the figure below.
3. Should a failure occur during use, you may inform the Austria Email customer service,
or after appropriate consultation, call a licensed electrician. Please do not attempt to
repair a fault yourself. For professionals, it usually just takes a few moments and your
immersion heater is working again.

WARRANTY

1. Warranty period
The warranty period is prescribed by law for all household appliances. An appliance that
is designed for the household but is used commercially has a warranty of 6 months. The
warranty period begins with the acceptance of the appliance.
2. Terms of warranty
The warranty takes effect with the acceptance of the appliance and the settling of the
invoice. Always retain the warranty certificate that was filled out by the vendor, the invoi-
ce, the delivery note or other proof of purchase.

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Sh-3,0Sh-2,5Sh-1,5Sh-4,5Sh-7,5Sh-6,0 ... Alle anzeigen

Inhaltsverzeichnis