Epson SR-600 Bedienungsanleitung Seite 12

English
Inserting and Removing a CD-ROM
To insert a CD-ROM into the CD-ROM drive, follow the steps
below.
CAUTION:
Do not adjust the LCD angle when the CD-ROM drive tray is open. The
CD-ROM drive may be damaged. Make sure that the CD-ROM drive
tray is fully inserted into the CD-ROM drive before performing the
following procedure.
1. Slide the LCD all the way down
as described in the previous
section of this manual.
2. Open the CD cover.
3. Press the eject button of the
CD-ROM drive. The tray comes
out a short distance.
4. Pull the tray out gently as far as
it will go.
5. Hold the CD-ROM with the label
side up and carefully put the
CD-ROM in the tray.
Push the CD-ROM down slightly to
ensure that it is firmly set in the
CD-ROM tray. If the CD-ROM is not
firmly set in the tray, it may be damaged.
6. Gently push the tray into the CD-ROM drive.
Removing a CD-ROM
To remove a CD-ROM, follow the steps below:
1. Check that the CD-ROM access LED is off.
2. Press the eject button; the tray comes out slightly.
3. Pull the tray out gently as far as it will go.
4. Carefully lift the CD-ROM out of the drive.
12 SR-600 User's Manual
CAUTION: