Lubrication Tubes; Contents - SKF LAGD 400 Bedienungsanleitung

2.4 Lubrication tubes

The lubrication tubes are made from black nylon that has a high bursting strength.
Genuine SKF tubes must be used. The grease can be pumped through the tubes a
minimum distance of 5 metres (16 ft). A maximum distance of 10 metres (32 ft) is
possible during favourable conditions. Favourable conditions include low viscosity grease,
high ambient temperature and low back-pressure at the application.

2.5 Contents

The lubricator is supplied with:
• 20 m (65 ft) of lubrication tube
• 8 lubricator tube nuts (complete with 16 compression fittings)
• 8 threaded connectors (G 1/4)
• 8 steel plugs for unused outlets
(Unused outlets must be plugged to ensure proper operation.)
• 2 Y-connectors
• 1 filling nipple
• 1 grease cartridge LGMT 2/0.4
• 1 SKF Dial/Set program (MP3506).
This software calculates the required quantity of grease a day for an application.
Note Y-connectors:
One tube cannot feed two lubrication points through a Y-connector.
The grease always flows to the lubrication point with less resistance.
The other lubrication point will receive less than required.
6 SKF LAGD 400