Installation; Mounting /Removal - Westermo RS-232 Installationsanleitung

6. Installation

6.1 Mounting /Removal

Before mounting or removing the unit:
!
Prevent damage to internal electronics from electrostatic discharges (ESD)
by discharging your body to a grounding point (e.g. use of wrist strap).
Prevent access to hazardous voltages by disconnecting the unit from AC/DC mains
supply and all other electrical connections.
Mounting
This unit should be mounted on 35 mm DIN-rail which is horizontally mounted on a wall
or cabinet backplate.
This unit uses convection cooling. To avoid obstructing the air
flow around the unit, use the following spacing rules. Minimum
spacing 25 mm (1.0 inch) above/below and 10 mm (0.4 inches)
left/right the unit.
Snap on mounting, see figure.
Min
10 mm
Removal
Press down the black support at the back of the unit
using a screwdriver, see figure.
22
25 mm
25 mm
6157-2003